Sinee EM100-0R7-1B User Manual

User Manual
EM100 Mini Inverter
1
Preface
Thank you for purchasing EM100 series mini inverter.
Document No.: 31010008
Version No.:103
Issue Date: 06/03/2013
EM100 mini inverter is a compact, intuitive, reliable and performing AC variable speed
drive for 3-phase induction motors.
This manual offers the general information of installation, wiring, function parameters,
daily maintenance, and fault diagnosis of EM100 mini inverter.
It is the duty of any user to perform the appropriate, correct installation or configuration
of the optional parameters of the devices. Neither SINEE nor its distributors shall be
responsible or liable for misuse of the information contained herein or mismatching the
inverter with the motor.
In the interests of commitment to a policy of continuous development and improvement,
SINEE reserves the right to update the specification of the product or its performance, or
the content herein without notice.
More updates and information are available at www.sinee.cn.

Sinee EM100-0R7-1B Specifications

General

Rated Power	0.75 kW
Output Voltage	220V AC
Frequency	50Hz/60Hz
Operating Temperature	-10 to 40°C
Protection Features	Overload, Overvoltage, Undervoltage, Short Circuit

Summary

Safety Information

Safety Precautions

Details safety precautions before installation and during installation.

Precautions After Power-on

Details safety precautions after power-on, during operation, and maintenance.

Installation

Mechanical Installation

Covers mechanical installation recommendations, site selection, and precautions.

Wiring

Provides detailed instructions and considerations for wiring the inverter.

Keypad Operation

Keypad Operation Modes

Function Setting Procedures

Guides on viewing and editing parameters, saving, and resetting them.

Fault Reset and Monitoring

Details procedures for resetting faults and monitoring fault status.

Autotuning Motor Parameters

Parameter Tables

General Parameters (F00 Group)

Motor Parameters (F01 Group)

Details parameters related to motor configuration and settings.

Input Terminal Parameters (F02 Group)

Describes parameters for configuring multi-function input terminals.

Output Terminal Parameters (F03 Group)

Details parameters for configuring multi-function output terminals.

Start/Stop Control Parameters (F04 Group)

Covers parameters related to inverter start, stop, and braking control.

V/F Control Parameters (F05 Group)

Describes parameters for Voltage/Frequency (V/F) control.

Auxiliary Function Parameters (F06 Group)

Details auxiliary functions and parameters for enhanced operation.

Fault and Protection Parameters (F07 Group)

Lists parameters for fault detection, protection, and retry settings.

Preset Speed and PLC Parameters (F08 Group)

Covers parameters for preset speed settings and PLC operations.

Process PID Parameters (F09 Group)

Details parameters for PID control loop configuration.

Communication Parameters (F10 Group)

Describes parameters for communication settings like Modbus and RS485.

User Parameters (F11 Group)

Troubleshooting

Fault and Corrective Action

Lists common fault codes, their causes, and recommended corrective actions.

Common Fault and Troubleshooting

Addresses common issues like parameter setting failures and abnormal motor operation.

Inverter Overheating

Inverter Stops Output While Motor Runs

EMC (Electromagnetic Compatibility)

Grounding

Maintenance and Inspection

Maintenance and Inspection Procedures

Appendix A: EM100 Modbus Communication Protocol

Explanation of Command