Imaging
6-3
of 11 characters. On the exam type management interface, the character U is attached on the
exam type defined by the user.
On the exam type management interface, operations listed in Table 6-2 are defined for
user selection.
Table 6-2 Hotkeys for Exam Type Menu
Operation Hotkey Function
Delete D To delete a user-defined exam type.
Rename N To modify the exam type name.
Reset R
To reset the system’s predefined image control
parameters of the selected exam type.
Set Default S
To set the current selected exam type as the current
applied default exam type or set the current selected
application as default application type.
Update U
To save the current image control parameters information
to the selected exam type.
View V
To view the image control parameters of the current
selected exam type.
6.2.2.2 Display of Exam Type
The exam type name is displayed on the bottom left of the screen. In front of the default
exam type, the modified exam type, and the user-defined exam type, #,
*
, and U are
marked respectively.
6.2.2.3 Information of Exam Type
a) Default Exam Type: Each probe supported by the system has a default application.
Each application has a default exam type. The user can change the default exam
type on the exam type menu. The system uses a default exam type while turning
on the power, switching probe, or changing application type.
b) Current Exam Type: The current exam type is displayed as a selected mode in the
exam type menu. The current exam type includes a probe name, application name,
and exam type information.
To Next Page
Loading...
