DK32S User Manual (V1.3)
- 55 - 2022 SIYI Tech All Right Reserved
OFF to give back control to slave transmitter.
LINK
Bind master transmitter to slave transmitter.
5.9.1 Steps through Using Trainer Cable
1. Use trainer cable to connect the two DATA1 ports of master transmitter and
slave transmitter.
2. Go to “Trainer Mode” page. It displays a list of all 16 channels.
3. Turn FUNC to “Wired” and assign “Master” transmitter and “Slave” transmitter.
4. When you are to define a physical switch for trainer mode control, tap on
“NULL”, it displays “select a switch by operating it”. Then operate a switch, it
goes to switch status page for defining its stages.
To Next Page
Loading...