SIYI DK32S - 7.2 Voltage Calibrating

To Next Page

To Previous Page

DK32S User Manual (V1.3)

1. Prepare two DK32S transmitters, mark them with 1 and 2;

2. Please link the transmitter 1 to the sky station first, then turn on “Remote

Control Relay” in the “General Settings Relay” menu; the transmitter 1 is the

slave transmitter;

3. Then link the transmitter 2 to the sky station; the transmitter is always the

master transmitter even if you restart the sky station or transmitter.

7.2 Voltage Calibrating

Before using the sky station, it is necessary to calibrate the telemetry voltage of

both the sky station and the aircraft.

Here are some preparing work before calibration:

1. Power on the sky station and the transmitter;

2. Link the sky station to the transmitter.

Steps to Calibrate the Telemetry Voltage of the Sky Station (RX)

1. Power on the sky station through any of the PWM port, the voltage range is

from 3.6V to 10V, measuring by a multi-meter;

2. Let’s take an example of 6.0V; select “Standard Voltage” in the RX menu, tap