SIYI DK32S - Page 57

DK32S User Manual (V1.3)
- 57 - 2022 SIYI Tech All Right Reserved
2. Turn FUNC to “Wireless” and assign “Master” transmitter and “slave”
transmitter.
3. When you are to define a physical switch for trainer mode control, tap on
“NULL”, it displays “select a switch by operating it”. Then operate a switch, it
goes to switch status page for defining its stages.
4. After defining, the switch takes over control of turning on / off trainer mode, so
that master transmitter can take over control from slave transmitter in
emergency.
5. If you turn on Joystick Control, master transmitter will take over control
immediately by operating joysticks.
6. Start linking/binding master transmitter to slave transmitter by tapping on “LINK
- Start”. Transmitter indicator turns to blink red fast. Then repeat the operation
on slave transmitter, linking/binding is finished when transmitter indicator turns
to green.
7. Wireless trainer setting is finished successfully.
Mark:
Slave Transmitter Indicator Green: Master and slave transmitter in communication.
Slave Transmitter Indicator Yellow: Master and slave transmitter off communication.