SKF KFA1 series User Manual

7. Electronic control unit Page 37
EN
Table 20. Explanation of display contents of the three-digit LED display (KFAS)
Display
Explanation of
characters
Explanation
Value range
Factory setting
t = timer
PA = PAuse
"Interval time in timer mode" parameter
The displayed value(s) refer(s) to the interval time of
the lubrication cycle
0.1 h to 99.9 h
10 h
c = counter
PA = PAuse
"Interval time in counter mode" parameter
The displayed value(s) refer(s) to the interval time of
the lubrication cycle
1 - 999 Pulses
-
t = timer
CO = COntact
"Contact time in timer mode" parameter
The displayed value(s) refer(s) to the contact time of
the lubrication cycle
0.1 min – 99.9 min
KFA…W.. designs min 0.6 min
configuration-
dependent
c = counter
CO = COntact
Special application. Not applicable to the piston
pump units with reservoir described in these
instructions.
-
-
C = Cycle
O = OFF
P = Pressure
"Monitoring function" parameter
CS - Progressive distributor monitoring using a
cycle switch.
PS - Setting not permitted
OFF - Progressive distributor monitoring is deactivated.
OFF
Cycle Switch
Value for "monitoring function" parameter
Progressive distributor monitoring using one cycle
switch.
-
-
Pressure Switch
Setting not permitted
-
-
OFF
Value for "monitoring function" parameter
Progressive distributor monitoring is deactivated.
-
-
Continued on next page

SKF KFA1 series Specifications

General

Brand	SKF
Model	KFA1 series
Category	Water Pump
Language	English