Skope ReFlex Upright - Page 29

29
SKOPE Reflex Upright Fridge, Freezer, Combo
Troubleshooting
Service Manual
• Product is too warm. • Frequent door opening. • Limit door openings.
• Recently loaded. • Allow time for the product
to cool down.
• Door not closing properly. • Check and clean door
gasket.
• Refrigeration cartridge
operating too hot.
• Excessive door opening
or refrigeration heat load.
• Ensure the cabinet has
good ventilation around
the refrigeration
cartridge.
• Ensure the cabinet is
within the maximum
operating conditions.
• Set point is to high. • Lower set point.
• Moisture build up on door
or exterior.
• High humidity. • Check ambient operating
temperature and
ventilation requirements,
and reposition cabinet if
necessary.
• Frequent door opening. • Limit door openings.
• Door not closing properly. • Check and clean door
gasket.
• Cabinet door does not
shut properly.
• Cabinet is on an uneven
surface.
• Level the cabinet.
• Door is obstructed. • Check shelves and
product.
• Warm cabinet
temperatures.
• Compressor operating for
long periods (more than 1
hour).
• Blocked condenser. • Clean the condenser.
• Poor ventilation around
refrigeration cartridge.
• Ensure the cabinet has
good ventilation around
the refrigeration
cartridge.
• Ensure the cabinet is
within the maximum
operating temperature.
• Refrigeration fault. • Swap cartridge and
service faulty cartridge as
required.