47
SKOPE Reflex Upright Fridge, Freezer, Combo
Replacement Procedures
Service Manual
To replace the fan motor (with correct SKOPE spare part only)
Evaporator
Tub
The evaporator tub is screwed onto the evaporator assembly via plastic
corner brackets. A long screw-driver may be required to reach the tub plastic
corner bracket screws.
The evaporator tub should only be removed if necessary, not for routine
maintenance. Take care when refitting as misalignment may damage the
tub.
1. Remove the condenser fan assembly and the fan blade (see previous
page).
2. Detach the fan motor from the fan mounting brackets by removing the four
screws from the mounting bracket.
3. Fit new motor and reattach fan blade with existing 12mm flat washer and
serrated head screw. Tighten the blade to recommended torque setting.
4. Refit the condenser fan assembly to the cartridge. Following the same path
as the original cable, secure the condenser fan motor cable with cable ties
as necessary.
5. Reassemble and test.
Evaporator tub (viewed from the back)
Plastic corner bracket
To Next Page
Loading...
