33
SKOPE Reflex Upright Fridge, Freezer, Combo
Replacement Procedures
Service Manual
To replace an interior light component
To replace the LED driver power supply
1. Unplug the cabinet from the power supply.
2. Remove shelves to allow
access to light.
3. Unplug the light.
4. Unscrew and replace the
light.
5. Plug the light in and
reassemble the shelves.
6. Reconnect to the power supply and check for correct operation.
1. Unplug the cabinet from the power supply.
2.
Open the door/s, unscrew the front panel - (Phillips head screwdriver): Two
screws on the bottom edge of the panel.
Swing the front panel up and tape/
restrain safely in place (see picture on page 42).
3. Unplug, unscrew and replace the light power supply.
4. Reassemble and test for correct operation.
To Next Page
Loading...
