58
Skydio X2 Color/Thermal - Operator Manual © 2022 Skydio, Inc. All rights reserved.
Maintenance
For optimal performance, Skydio recommends replacing your propellers after 100 hours of flight time or if they are
damaged. Always replace all three propellers in the hub. Replacing all three propellers will reduce any potential
variation between the propellers and track propeller flight time.
If you purchased the Skydio X2 Propeller Kit or an X2 bundle, you received
the equipment necessary to replace your propellers:
• clockwise (CW) propellers blades (6)
• counter clockwise (CCW) propeller blades (6)
• replacement propeller screws (12)
• torque driver tool that is included with your Skydio X2
Replace propeller blades
WARNING: Propellers with hairline cracks or large breaks, chops, or bends should be replaced immediately. Do NOT
fly the X2 with propellers that are not in good condition as serious bodily harm or injury may occur.
WARNING: Propeller blades are sharp. Handle with care. Always ensure X2 is turned o before replacing the
propellers to avoid injury. Do NOT attempt to replace your X2 propellers while the Skydio X2 is powered on. Doing
so is an extreme safety risk and may lead to serious bodily harm or injury.
Step 1 - Identify the damaged propeller
Step 2 - Hold onto the motor or the propeller hub to stabilize the motor
Step 3 - Unscrew the propeller pin using the Torque driver
• slide the propeller out of the propeller hub, then repeat with the
remaining two propellers in the hub
• replace all three propellers in that hub. All three replacement
propellers must come from the same replacement kit
• dispose of the removed propellers
To Next Page
Loading...
Need help?
General
