62
Skydio X2 Color/Thermal - Operator Manual © 2022 Skydio, Inc. All rights reserved.
Maintenance
Step 2 - Remove the damaged hard stop(s)
• extend the arm that is either above or below the arm
with the damaged hard stop
• leave the arm with the damaged hard stop folded in
• loosen the hard stop screw using the T3 driver
• remove the screw and set aside - you will reuse it
Step 1 - Identify the damaged hard stop
• rotate the hard stop so the flange protrudes from
the drone
• grab the hard stop by the flange and pull out to
remove - rotate the hard stop back and forth to
dislodge it from the drone
Replace hard stops
To Next Page
Loading...
