72
Model MMV Rev. 10/11
Operation
Fuel Cap
The fuel cap (1) is conveniently located on the left side of the vehicle.
The fuel cap meets EPA standards.
To remove the fuel cap:
1. Level the vehicle, ground the attachment, place the travel select
lever in (N) NEUTRAL, move the neutral lock lever to the (N) NEU-
TRAL LOCK position, engage the parking brake switch and turn the
ignition switch to the OFF position.
2. Slowly turn the cap in a counter-clockwise rotation. Wait for any
“hissing” noise to stop. THEN unscrew the cap all the way and
remove the cap from the filler neck.
To install the fuel cap:
Turn the cap clockwise until the cap bottoms on the filler neck. The fuel
cap is now properly installed.
WARNING: REMOVE FUEL CAP SLOWLY. Fuel
spray may cause personal injury. Fuel can spray out on you if
you open the cap too quickly or if you fill the tank too rapidly.
To Next Page
Loading...