Need help?Do you have a question about the Skytrak MMV and is the answer not in the manual?
General| Brand | Skytrak |
|---|---|
| Model | MMV |
| Category | Front End Loaders |
| Language | English |
Covers accident prevention tags and requirements for new operators.
Describes accelerator, brake, steering, and horn controls.
Explains the function and positions of the ignition switch.
Details how to select between front, crab, and four-wheel steering.
Operation of the parking brake switch and its interaction with Stabil-TRAK.
Overview of joystick controls for boom, tilt, and sway.
Explains default joystick operation for boom lift, lower, extend, retract.
Joystick operation for attachment tilt and boom extend/retract.
Joystick operation for boom lift/lower and attachment tilt.
Joystick operation for boom lift/lower and frame sway.
Description of the main dash panel gauges and indicators.
Details critical warning lights for transmission, hydraulic, and engine oil.
Explains the LMI system's function and alerts.
Comprehensive checklist of essential pre-operation checks.
Step-by-step guide for starting the vehicle's engine.
Specific instructions for starting in low temperatures, including grid heater use.
Important notes regarding steering mode changes and selection.
Guidance on locating and using capacity charts for safe load handling.
Guidance on safely handling loads using the LMI system.
Safety and preparation steps for lifting personnel and platform requirements.
Steps for safely shutting down the vehicle engine and systems.
Procedures for lowering the boom due to power loss or hydraulic failure.
Step-by-step guide for addressing hydraulic line failures.
Details maintenance tasks for 10-hour and first 50-hour intervals.
Details maintenance tasks for 250-hour intervals.
Details maintenance tasks for 1000-hour and 2000-hour intervals.
Specifies lubrication points and fork shaft/wear bar lubrication.
Procedures for changing air cleaner elements.
Oil type recommendations and procedure for checking oil level.
Steps for changing engine oil and filter.
Steps for replacing the fuel filter.
Steps for changing hydraulic oil and filter.
Steps for changing axle oil.
Steps for changing wheel end oil.
Steps for changing transfer case oil.
Procedure for checking and maintaining proper tire inflation.
Procedure for checking boom chain tension and sag.
Procedure to adjust tension in the top boom extend chains.
Procedure for replacing worn boom wear pads based on indicators.
Instructions and procedure for testing the Stabil-TRAK system.
Procedures to test the parking brake and transmission de-clutch system.
Test procedure for the parking brake's ability to hold the vehicle on a grade.
To Next Page