To Next Page
P
pwintersSep 8, 2025
What to do with changing between wintertime and summertime operation on SMA Inverter?
- LLaura SantiagoSep 8, 2025
Save two different parameter sets on the SD card and activate them via the '550.02 ParaLod' parameter.
What to do with changing between wintertime and summertime operation on SMA Inverter?
Save two different parameter sets on the SD card and activate them via the '550.02 ParaLod' parameter.
What to do if my SMA SI 5048 Inverter battery cell can no longer be used?
Remove the unusable cell from your battery bank. Start the Sunny Island and change the battery voltage in the QCG under 'New Battery'.
What causes high outputs being transferred back and forth between the clusters in my SMA Inverter?
If high outputs are being transferred back and forth between the clusters, the nominal frequencies and voltages are defined differently. Correct this by means of the appropriate parameters.
General| Model | SMA SI 5048 |
|---|---|
| Rated Power | 5000 W |
| Max. Apparent AC Power | 5000 VA |
| AC Nominal Voltage | 230 V |
| Battery Voltage | 48 V |
| Operating Temperature Range | -25°C to +60°C |
| Protection Class | IP65 |
| Number of MPP Trackers | 2 |
| Type | Inverter |
| AC Voltage Range | 180 V - 280 V |
Highlights critical safety instructions and warnings for operating the Sunny Island.
Details potential dangers like electric shock, burns, and device destruction.
Provides guidelines for choosing a safe and suitable location for mounting the device.
Step-by-step instructions for mounting the Sunny Island using a wall bracket.
Details the requirements and procedures for grounding the Sunny Island correctly.
Instructions and precautions for making the DC connections to the Sunny Island.
Explains how to connect the Sunny Island to AC power sources (Loads/Sunny Boys, Generator/Grid).
Lists the prerequisites and important steps before starting the commissioning process.
Step-by-step guide to starting and using the Quick Configuration Guide for setup.
Procedure for setting up and calibrating the battery current sensor.
Detailed steps for activating the Sunny Island and starting the QCG.
Instructions on how to put the Sunny Island into standby mode.
Procedure for completely switching off the Sunny Island.
Steps to safely disconnect the Sunny Island from all voltage sources.
Instructions on how to view and modify device parameters.
Procedure for entering the installer password to access advanced settings.
Details how warnings and failures are displayed, including error codes and indicators.
Details the load shedding function to protect batteries from deep discharge.
Explains how the Sunny Island handles overload and short-circuit conditions.
Describes how the device handles faults and the autostart functionality.
Explains the IUoU charge control procedure and phases.
Guidance on connecting and managing generators as an external energy source.
Explanation of how the Sunny Island operates with the main power grid and stand-alone grid.
Describes the operation when the main grid is disconnected and the Sunny Island powers the grid.
How to connect multiple Sunny Islands to form a multicluster system via communication cables.
Steps for the initial setup and configuration of a multicluster system.
Procedure for activating and deactivating the entire multicluster system.
Procedure for updating firmware across all devices in a multicluster system.
How to configure PV inverters for stand-alone grid operation.
Detailed lists of all adjustable parameters for various system settings.
Procedure for confirming and resolving errors to return the Sunny Island to operation.
Classification of failures into five levels based on severity and required interaction.
Lists of specific warnings and fault codes for different categories (INV, BAT, EXT, GEN, GRD, RLY, SYS, AUX).
Common questions and answers for troubleshooting practical issues with the Sunny Island.
Step-by-step guide for activating and managing emergency battery charging.
