SMA Solar Technology AG Commissioning
Installation Guide SWebBox20-IEN110711 29
6. In the "IP Address" field enter the static IP address, under which the Sunny WebBox is to be
reachable in the local network (see section 13.7 "Allocating an IP Address in a Local Network"
(page 58)).
7. In the "Subnet mask" field, enter the subnet mask of your network. Normally, you can find this
information in the router manual.
8. Select [Save].
☑ The Sunny WebBox saves the network settings. The save procedure can take up to 30
seconds. Do not disconnect the Sunny WebBox with Bluetooth from the electricity supply
during the save procedure. The save procedure is complete when you are directed to the
new IP address or the Sunny WebBox is no longer available via the web browser.
9. When the save procedure is completed, remove the plug-in power supply of the Sunny WebBox
from the plug socket.
10. Remove the network cable (blue).
☑ The local network settings are applied to the Sunny WebBox.
You may now connect the Sunny WebBox to the local network (see section 30).
Resetting the computer to the network settings.
Reset you computer to the original network settings, in order that you can reach it via the
local network when required (see section 6.4 "Configuring Network Settings on the
Computer" (page 23)).
To Next Page
Loading...
