SMA SUNNY WEBBOX - Setting the HTTP Port; Setting the NAT Port

SMA Solar Technology AG Extended Configuration
Installation Guide SWebBox20-IEN110711 33
7.1.4 Setting the HTTP Port
The HTTP port is the network port under which the Sunny WebBox user interface is available. The
HTTP Port is set to 80 by default. Should another port be entered, this is to be explicitly specified
during call up of the user interface.
Example: The Sunny WebBox IP address is 192.168.0.168 and the HTTP port was changed to
8080; thus "http://192.168.0.168:8080" must then be entered in the address bar of the web
browser.
1. Select the Sunny WebBox in the plant tree and select "Settings" in the device menu.
or
Select "Settings" on the toolbar.
2. Select the "External Communication > HTTP" parameter group.
3. Select [Edit].
4. Enter the required port in the "Port" field. (Status upon delivery: Port 80)
5. Select [Save].
☑ The HTTP port is saved.
7.1.5 Setting the NAT Port
During data transfer, the Sunny WebBox sends the IP address and port at which the Sunny WebBox
is available on the internet to the Sunny Portal. For this, the respective port must be released by the
router. If the NAT (Network Address Translation) in the router is changed, you must specify the
network port set in the router. The NAT Port is set to 80 by default.
1. Select the Sunny WebBox in the plant tree and select "Settings" in the device menu.
or
Select "Settings" on the toolbar.
2. Select the "External Communication > Ethernet > Nat" parameter group.
3. Select [Edit].
4. Enter the required port in the "Port" field.
5. Select [Save].
☑ The NAT port is saved.
Adjusting the network ports
Changing the ports is only necessary in rare cases. Before adjusting the ports, contact your
network administrator.
Adjusting the network ports
Changing the ports is only necessary in rare cases. Before adjusting the ports, contact your
network administrator.