SMART Board SB480iv2 - Projector Status and Control

APPENDIX A
REMOTELY MANAGING YOUR SYSTEM THROUGH A NETWORK INTERFACE
48 smarttech.com/kb/170782
Projector Status and Control
This menu allows you to set projector status, image options and audio options.
Submenu setting Description
Projector Status
l
Click Refresh to update the projector status.
l
Click Power ON to turn on the projector.
l
Click Power OFF to turn off the projector.
l
Click Set to save changes to Projector Status options.
l
Click Clear to reset Projector Status options.
Projector Status Displays the projector’s status.
Auto Power Off (Min) Sets the length of the auto power-off countdown timer between 0
to 120 minutes in five minute increments.
Alert Status Displays the projector’s error status.
Image Control
Ceiling Mount Sets the projector position (Front, Front Ceiling, Rear, Rear
Ceiling).
Input Sets the video input source (HDMI, Computer 1, Computer 2,
Video).
Color Mode Sets the projector’s display output (Dynamic, PC, Movie, Gamer,
User).
AVMute Turns on or turns off the video source’s audio output.
Aspect Ratio
Sets the image output to Auto, 4:3, 16:9 and 16:10.
Brightness
Sets projector brightness from 0 to 100. Click Set to save the new
brightness setting.
Contrast Sets the difference between the lightest and darkest parts
of the image from 0 to 100.
Audio Control
Volume Sets the audio output from 0 to 32.
Mute Turns on or turns off the projector’s audio output.