SMART Board SB480iv2 - Other Precautions; Environmental Requirements

IMPORTANT INFORMATION
iv smarttech.com/kb/170782
Other precautions
If you own a SMARTproduct other than a SMARTBoard 480iv2 interactive whiteboard system or
SMARTBoard M680Viv2 interactive whiteboard system, refer to the installation manual for your
product for relevant warnings and maintenance instructions.
Environmental requirements
Before you install your SMARTBoard interactive whiteboard system, review the following
environmental requirements.
Environmental
requirement
Parameter
Interactive whiteboard
operating temperature
l
41°F to 95°F (5°C to 35°C) from 0' to 6000' (0 m to 1800 m)
l
41°F to 86°F (5°C to 30°C) from 6000' to 9800' (1800 m to 3000 m)
Projector operating
temperature
l 41°F to 104°F (5°C to 40°C) from 0' to 2500' (0 m to 762 m)
l 41°F to 95°F (5°C to 35°C) from 2500' to 5000' (762 m to 1524 m)
l 41°F to 86°F (5°C to 30°C) from 5000' to 10 000' (1524 m to 3048 m)
Storage temperature -4°F to 122°F (-20°C to 50°C)
Humidity
l
5% to 80% operating relative humidity, non-condensing
l
5% to 80% storage relative humidity, non-condensing
Water and fluid
resistance
l
Intended for indoor use only. Doesn’t meet any salt-spray or water
ingress requirements.
l
Don’t pour or spray liquids directly onto your interactive whiteboard,
the projector or any of its sub-components.
Dust
l
Intended for use in office and classroom environments. Not for
industrial use where heavy dust and pollutants can cause
malfunctions or impaired operation. Periodic cleaning is required in
areas with heavier dust. See Cleaning the projector on page27 for
information on cleaning the SMARTV30 projector. See Cleaning
the air filters on page31 for information on cleaning the air filters in
the SMARTV30 projector.
Electrostatic discharge
(ESD)
l
EN61000-4-2 severity level 4 for direct and indirect ESD
l
No malfunction or damage up to 8 kV (both polarities) with a
330ohm, 150 pF probe (air discharge)
l
Unmated connectors meet no malfunction or damage up to 4 kV
(both polarities) for direct (contact) discharge
Cables All SMARTBoard interactive whiteboard system cables should be
shielded to prevent potential accidents and degraded video and audio
quality.