Appendix C Managing SMARTBoard MX (V3, V2, and V2-C) series displays using RS-232
smarttech.com/kb/171555 100
Power state Description
READY The screen is off, but the display is ready to turn on when one of the following
occurs:
l
A user presses the Power button on the convenience panel or the remote
control.
l
You send the setpowerstate=on command.
l
The display receives a video signal.
STANDBY The screen is off, and the display is in a low power state. The display enters READY
or ON state when one of the following occurs:
l
A user presses the Power button on the front control panel or the remote
control.
l
You send the setpowerstate=standby command.
This power state is the default energy saving mode for displays set to a non-EU
location.
Note
The EU uses “networked standby” to describe this power state.
POWERSAVE The screen is off, and the display is a very low power state. The display enters
READY or ON state when one of the following occurs:
l
A user presses the Power button on the front control panel or the remote
control.
l
You send the setpowerstate=ready or setpowerstate=on command.
This power state is the default energy saving mode for displays set to an EU
location.
Note
The EU uses “standby” to describe this power state.
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of getpowerstate and setpowerstate, commands are available only when the
display is in READY or ON power state.
To Next Page
Loading...
Need help?
General
