Appendix 7 Adjusting display settings
smarttech.com/kb/171861 77
Option Values Function Notes
Switch to active input
automatically
OFF
ON
SELECT
Automatically switches the input
when an active video signal is
connected to the display, or displays
a user-notification.
[N/A]
External source display settings
HDMI OUT format 3840 × 2160_
60HZ
1080P_60HZ
Sets the HDMI out resolution. Ensure the device that receives the
display’s HDMI out signal matches
the selected output resolution.
For best results, make sure the
device that receives the display’s
HDMI out signal uses the same
resolution settings as the display.
Advanced HDMI settings [N/A] Set the HDMI-EDID version for
individual digital video inputs.
Note
HDMI 2.0 is the default.
When HDMI 1.4 is selected, the
display presents itself as an HDMI 1.4
compliant device with a video
resolution limit of 3840 × 2160 @
30Hz.
When EDID 2.0 is selected, the
display presents itself as an HDMI
2.0 compliant device with a video
resolution limit of 3840 × 2160 @
60Hz.
Note
This setting can be applied
differently to each digital video
source.
PC HDMI 1.4
HDMI 2.0
[N/A] This option is available when an OPS
PC module is installed in the display’s
accessory slot.
HDMI1 HDMI 1.4
HDMI 2.0
[N/A] Side connector panel.
HDMI2 HDMI 1.4
HDMI 2.0
[N/A] Side connector panel.
HDMI3 HDMI 1.4
HDMI 2.0
[N/A] Front connector panel.
TYPE_C1 HDMI 1.4
HDMI 2.0
[N/A] Side connector panel.
TYPE_C2 HDMI 1.4
HDMI 2.0
[N/A] Front connector panel.
DP HDMI 1.4
HDMI 2.0
[N/A] Bottom connector panel.
To Next Page
Loading...
