Smartgen HGM9510 - Controller Operation and Interface; Indicator Lights Explained; Controller Pushbutton Functions

HGM9510 GENSET PARALLEL UNIT
HGM9510 Genset Parallel Unit ISSUE 2013-08-06 Version 1.1 Page 10 of 65
5 OPERATION
5.1 INDICATOR LIGHT
NOTE: Selected light indicators description:
Warning indicator and Alarm indicator:
Alarm Type
Warning Indicator
Alarm Indicator
Warning
Slow flashing
Slow flashing
Trip Alarm
Slow flashing
Slow flashing
Shutdown Alarm
Off
Fast flashing
Trip and Stop Alarm
Off
Fast flashing
Running indicator: illuminated from crank disconnect to ETS while off during other periods.
Genenerator normal light：It is light on when generator is normal; flashing when generator state is
abnormal; off when there is no generator power.
5.2 PUSHBUTTONS
Stop
Stop running generator in Auto/Manual mode; Lamp test
(press at least 3 seconds); Reset alarm in stop mode;
During stopping process, press this button again to stop
generator immediately.
Start
Start genset in Manual mode.
Manual Mode
Press this key and controller enters in Manual mode.
Auto Mode
Press this key and controller enters in Auto mode.