HGM9510 GENSET PARALLEL UNIT
HGM9510 Genset Parallel Unit ISSUE 2013-08-06 Version 1.1 Page 13 of 65
Volt difference, freq difference, angle difference, active power percentage, target active power
percentage, reactive power percentage, target reactive power percentage, GOV percentage, AVR
percentage and MSC status
★Alarm:
NOTE: For ECU alarms and shutdown alarms, if the alarm information is displayed, check
engine according to it, otherwise, please check the generator manual according to SPN alarm
code.
★Event log
Make records about all start/stop events (shutdown alarm, trip and stop alarm, manual /auto start
or stop) and the real time when alarm occurs.
★Others, including,
Time and Date, maintenance due, input/output ports status.
★About, including,
Issue time of software and hardware version, product PD number.
5.3.2 USER MENU AND PARAMETERS SETTING MENU
Press key for more than 3s to enter into user manual.
★Parameter
After entering the correct password (factory default password is 00318) you can enter parameter
settings screen.
★Language
Selectable Chinese, English and others (default: Espanol)
★Commissioning
On load, off load or custom commissioning can be chosen. Custom commissioning can configure
on load or not during commissioning, when to commissioning and select the mode after
commissioning (manual mode, auto mode and stop mode).
★Clear users’ accumulation
Can clear total run time A and B, total electric energy A and B.
Parameter setting including as following,
★Timer settings
★Engine settings
★Generator settings
★Load settings
★Breaker settings
★Analog sensor settings
★Input port settings
★output port settings
★Module settings
To Next Page
Loading...
Need help?
General
