Smartgen HGM9510 User Manual

HGM9510 GENSET PARALLEL UNIT
HGM9510 Genset Parallel Unit ISSUE 2013-08-06 Version 1.1 Page 14 of 65
★Scheduling and maintenance settings
★Synchronization settings
Return
>Start Delay
>Return Delay
>Preheat Delay
>Cranking Time
>Crank Rest Time
>Safety On Time
>Start Idle Time
>Warming Up Time
>Cooling Time
>Stop Idle Time
>ETS Hold Time
Form1: Use to scroll settings,
to enter settings (form 2), to exit
settings menu.
Timers >
Engine
Generator
Load
Breaker
Temp. Sensor
OP Sensor
Level Sensor
Config Sensor 1
Config Sensor 2
Return
> Start Delay
Form 2: Use to scroll settings,
to enter settings (form 4), to return to
previous menu. (form 1)
Timers >
> Return Delay
> Preheat Delay
> Cranking Time
> Crank Rest Time
> Safety On Time
> Start Idle Time
> Warming Up Time
> Cooling Time
> Stop Idle Time
> ETS Hold Time
Engine
Generator
Load
Breaker
Temp. Sensor
OP Sensor
Level Sensor
Config Sensor 1
Config Sensor 2
Return
> Start Delay
> Return Delay
> Preheat Delay
Form 3: Use to scroll settings,
to enter settings (form 4), to return to
previous menu. (form 1)
Timers >
Engine
Generator
Load
Breaker
Temp. Sensor
OP Sensor
Level Sensor
Config Sensor 1
Config Sensor 2
> Cranking Time
> Crank Rest Time
> Safety On Time
> Start Idle Time
>Warming Up Time
> Cooling Time
> Stop Idle Time
> ETS Hold Time

Smartgen HGM9510 Specifications

General

Brand	Smartgen
Model	HGM9510
Category	Controller
Language	English