HGM9510 GENSET PARALLEL UNIT
HGM9510 Genset Parallel Unit ISSUE 2013-08-06 Version 1.1 Page 56 of 65
transformer and input voltage must correct. Otherwise, the current of collecting and active power
maybe not correct.
NOTE: ICOM port must be connected to negative pole of battery.
WARNING! When there is load current, transformer’s secondary side prohibit open circuit.
5) Withstand Voltage Test
CAUTION! When controller had been installed in control panel, if need the high voltage test,
please disconnect controller’s all terminal connections, in order to prevent high voltage into
controller and damage it.
To Next Page
Loading...
