HGM9510 GENSET PARALLEL UNIT
HGM9510 Genset Parallel Unit ISSUE 2013-08-06 Version 1.1 Page 8 of 65
Start times can accumulate Max. 65535 times
Protection: automatic start/stop of the gen-set, ATS(Auto Transfer Switch) control with perfect
fault indication and protection function;
All output ports are relay output;
Parameter setting: parameters can be modified and stored in internal EEPROM memory and
cannot be lost even in case of power outage; most of them can be adjusted using front panel
of the controller and all of them can be modified using PC via USB or RS485 ports;
Multiple crank disconnect conditions (speed sensor, oil pressure, generator frequency) are
optional;
Widely power supply range DC(8~35)V, suitable to different starting battery voltage
environment;
Event log, real-time clock, scheduled start & stop generator (can be set as start genset once a
day/week/month whether with load or not);
Accumulative total run time and total electric energy of A and B. Users can reset it as 0 and
re-accumulative the value which make convenience to users to count the total value as their
wish.
Can control engine heater, cooler and fuel pump.
With maintenance function. Actions (warning, trip and stop, shutdown) can be set when
maintenance time out;
All parameters used digital adjustment, instead of conventional analog modulation with
normal potentiometer, more reliability and stability;
IP55 waterproofness level can be achieved with the help of rubber-ring gasket between shell
and control panel.
Metal fixing clips enable perfect in high temperature environment；
Modular design, anti-flaming ABS plastic shell, pluggable terminal, built-in mounting，compact
structure with easy installation；
To Next Page
Loading...
Need help?
General
