HMC6 Power Management Controller User Manual Page 69 of 87
Active when the Busbar under frequency 2 alarm
occurs.
Active when the Busbar under frequency 3 alarm
occurs.
Active when the Busbar over voltage 1 alarm occurs.
Active when the Busbar over voltage 2 alarm occurs.
Active when the Busbar over voltage 3 alarm occurs.
Active when the Busbar under voltage 1 alarm occurs.
Active when the Busbar under voltage 2 alarm occurs.
Active when the Busbar under voltage 3 alarm occurs.
Active when controller detects generator over power 1
occurs.
Active when controller detects generator over power 2
occurs.
Active when controller detects generator have reverse
power 1.
Active when controller detects generator have reverse
power 2.
Active when generator over current 1 occurs.
Active when generator over current 2 occurs.
Active when generator over current 3 occurs.
Active when generator over current 4 occurs.
Active when synchronization failure alarm.
Active when close failure alarm.
Active when open failure alarm.
Active when generator takes load while deactivate
when generator off load.
Active when the starting power requirement of heavy
consumer 1 is satisfied.
Active when the starting power requirement of heavy
consumer 2 is satisfied.
Active when the starting power requirement of heavy
consumer 3 is satisfied.
Active when start failure alarm.
Active in Semi-auto mode.
Active when light load is output.
Active when non-essential load 1 trip occurs.
Active when non-essential load 2 trip occurs.
Active when non-essential load 3 trip occurs.
Active when engine fault signal is output.
To Next Page
Loading...
Need help?
General
