To avoid personal injury, property damage, or accidental damage to the product, read all the
information in the Chapter before using the product.
Caution
1) Always perform vehicle diagnose in a safe environment.
2) Never operate the inspecting device while driving the vehicle to avoid distraction and cause
the traffic accident.
3) Before starting the engine, the handbrake should be pulled, especially the front wheels should
be blocked, and the gearshift lever should be placed in neutral (manual transmission) or P
gear (automatic transmission) to avoid starting the engine and making the vehicle to move and
to injure someone.
4) Exhaust gases from the engine contain a variety of toxic compounds (e.g. hydrocarbons,
carbon monoxide, nitrogen oxides, etc.), which can lead to slow response or even serious
personal injury or death, and the vehicle under test should be parked in a well-ventilated area
during operation.
5) Use extreme caution when operating around ignition coils, distributor caps, ignition circuits and
ignition plugs. The voltage generated by these parts while the engine is running is dangerous,
so operate them with proper insulation.
6) To avoid damaging the inspecting device or generating incorrect data, make sure that the
vehicle battery is fully charged and that the vehicle diagnostic seat is clean and security.
7) Vehicle accumulator liquid contains vitriol, which is corrosive to the skin, so please avoid direct
contact between the accumulator liquid and the skin, pay special attention not to splash into
the eyes, and strictly prohibit fire from approaching.
8) Keep clothes, hair, hands, tools, testers, etc. away from running or hot engine parts.
9) Please use the charger that comes with the product for charging. The Company is not
responsible for any damage or loss caused by charging with other chargers than those
specified by the Company.
10) Keep the inspecting device dry and clean, and away from gasoline, water and greasy items. If
necessary, clean the surface of the device with a clean cloth coated with a mild detergent.
11) The inspecting device must have all internal services performed by an authorized service
facility or an authorized technician. Attempts to disassemble or modify the device will void the
warranty.
To Next Page
Loading...