7. Reset
This module provides the quick entry for commonly used special function operation.
Notes: Specific maintenance functions, which are offered, depend on the model.
7.1 48V MHEV Test
The function is used for offline testing of 48V light hybrid parts.
7.2 Compressor Test
This function is used for testing after replacement and maintenance of vehicle compressor.
7.3 DCDC Test
The DC converter (DCDC) is a high-low voltage DC conversion converter for new energy
automobiles, and this function, mainly used for DC converter offline testing.
7.4 OBC Test
The on-board charger (OBC) is a charging device that converts AC power to DC power for new
energy vehicles, and this function, mainly used for offline testing for vehicle-mounted chargers.
7.5 Oil Reset Service
If the service lamp is on, run car diagnostics first for troubleshooting. After that, reset the driving
mileage or driving time, so as to turn off the service lamp and enable a new driving cycle.
7.6 A/F Reset
This function is applied to set or learn Air/Fuel ratio parameters.
7.7 Electronic Parking Brake Reset
This function enables you to reset the brake pad after replacing the brake pad.
It needs to be performed in the following cases:
1)
The brake pad and brake pad wear sensor are replaced.
2)
The brake pad indicator lamp is on.
3) The brake pad sensor circuit is short, which is recovered.
4)
The servo motor is replaced.
7.8 Steering Angle Calibration
This function enables you to reset the steering angle, after replacing the steering angle position
sensor, replacing steering mechanical parts (such as steering gearbox, steering column, end tie
To Next Page
Loading...