1) The exhaust back pressure sensor is replaced.
2) The PM trap is removed or replaced.
3) The fuel additive nozzle is removed or replaced.
4)
The catalytic oxidizer is removed or replaced.
5) The DPF regeneration MIL is on and maintenance is performed.
6) The DPF regeneration control module is replaced.
7.13 Gearbox Matching
This function enables you to complete the gearbox self-learning to improve gear shifting quality.
It needs to be performed in the following cases:
When the gearbox is disassembled or repaired.
7.14 Gear Learning
This function enables you to perform tooth learning for the car, to turn off the MIL.
It needs to be performed in the following cases:
1)
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is replaced.
2) The DTC 'tooth not learned' is present.
7.15 Motor Angle Calibration
When the rotor position detected by the motor angle position sensor is different from the actual
rotor field position, motor angle calibration must be performed.
7.16 Coolant Bleed
Use this function to activate the electronic water pump before venting the cooling system.
7.17 Engine Power Balance Monitoring
It is used to monitor crankshaft acceleration in the power stroke of each cylinder, to determine the
relative power provided by each cylinder.
7.18 IMMO Service
This function enables you to perform the anti-theft key matching function, so that the immobilizer
control system on the car identifies and authorizes remote control keys to normally use the car.
It needs to be performed in the following cases:
When the ignition switch key, ignition switch, combined instrument panel, ECU, BCM, or remote
control battery are replaced.
7.19 High Voltage Battery Diagnosis
To Next Page
Loading...