EasyManua.ls Logo

SmartSafe P13 - Network Settings; Account Registration

Default Icon
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
P13 User Manual
entering the desktop and view different functions.
Back to Previous Level: After opening an app, swipe from the left or right edge of the screen to
the center of the screen to go back to the previous level.
Back to Desktop: In full-screen state, swipe from the bottom edge of the screen to the center with
one finger to go back to the desktop.
View Recent Apps List: In full-screen state, swipe from the bottom edge of the screen to the
center of the screen and stay a little to open the recent apps list, swipe the screen left or right to
select and open any app in the list, press and hold the app and swipe up to close the app.
3.3.2 Split Screen Operation
Open Split Screen: After opening an app, swipe from the right edge of the screen to the center of
the screen to open the split screen function.
Close Split Screen: Press and hold the status button in the center of the split screen, and then
drag it to the left or right side for a certain distance to exit the split screen.
Close Split-Screen Apps: After split-screen, swipe up from the bottom of one side of the apps,
then close the corresponding apps and exit the split-screen.
3.4 Network Settings
The P13 tablet is equipped with two built-in Wi-Fi modules for communicating with the SLC and for
connecting to an external network to network the host.
To connect the host to an external network, follow the steps below to set up the device:
Notes: The power consumption of the device will increase when the wireless local area network
is enabled. It is recommended to turn off the wireless local area network to save power when it is
not in use.
1) On the main interface, tap Settings -> Network & Internet -> Wi-Fi.
2) Click or slide the WLAN on/off to turn it on and the device will start scanning for available
wireless networks automatically.
3) Select the network you want to connect to:
If you select an open network, you can connect to it directly.
If you select an encrypted network, you will need to enter an access password to connect.
4) When "Connected" is displayed, the connection is successful.
3.5 Account Registration
In the main interface, click Personal Center, the system pops up the following dialog box:

Table of Contents