It is used for high voltage battery diagnosis and status information detection.
7.20 Gas Particulate Filter Regeneration
After the GPF is used for a long time, fuel consumption is increased and engine output power is
reduced. In this case, the GPF replacement or regeneration must be performed.
7.21 Transport Mode
In order to reduce power consumption, the following functions may be disabled, including limiting
the vehicle speed, not waking up the door opening network, and disabling the remote control key,
etc. At this time, the transport mode needs to be deactivated to restore the vehicle to normal.
7.22 Tire Reset
This function is used to set the size parameters of the modified or replaced tire.
7.23 Windows Calibration
This feature is designed to perform door window matching to recover ECU initial memory, and
recover the automatic ascending and descending function of power window.
7.24 AdBlue Reset
After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset operation is
required.
7.25 NOx Sensor Reset
NOx sensor is a sensor used to detect the content of nitrogen oxides (NOx) in engine exhaust. If
the NOx fault is re-initialized and the NOx catalytic converter is replaced, it is necessary to reset
the catalytic converter learned value stored in the engine ECU.
7.26 Injector Coding
This function enables you to write injector actual code or rewrite code in the ECU to the injector
code of the corresponding cylinder, so as to more accurately control or correct cylinder injection
quantity.
It needs to be performed in the following cases:
After the ECU or injector is replaced.
7.27 Stop/Start Reset
This function is used to open or close the automatic start-stop function via setting the hidden
function in ECU (provided that the vehicle has a hidden function and supported by hardware).
To Next Page
Loading...