SEMI-AUTOMATIC
16
5 SMARTY Saver Plus power supply and accessories
5.1 Non-rechargeable battery SMT-C14031
The non-rechargeable battery SMT-C14031 is made up of 1 pack with 8 Li-MnO
2
cells
It is supplied with the AED, fully charged and ready to use; it was designed for long-lasting autonomy and to perform
approximately 200 full rescue cycles (shocks at 200J and CPR).
The estimated duration is approximately 3 (three) years from the installation of the AED and from the first activation
test, with the device in stand-by mode, i.e. with daily self-tests, daily self-tests with no subsequent AED switch-on.
If the level of residual charge in the battery is low, the user will be informed with audio and visual messages.
SMARTY Saver Plus will issue a warning of a low battery with a level ≤5% and an empty battery alarm with level ≤ 1%:
• WARNING: Residual battery level equal to or lower than 5%.
This warning will only be issued in Operation mode.
Battery level at 5% makes it possible to perform approximately 14 shocks and allows the device to
operate in stand-by mode for about 40 days
• ALARM: Battery residual capacity level ≤ 1%
This warning will be issued in both stand-by and operation mode.
With the battery at ≤ 1%, SMARTY Saver Plus makes it possible to perform approximately 7 shocks
and allows the device to operate in stand-by mode for about 20 days
We do not recommend using the device in this condition.
!!ATTENTION!!
In order to safeguard the duration of the battery SMT-C14031 and guarantee the automatic tests of the device, it is
recommended, after installing the battery, not to remove it until you replace it.
The removal and subsequent reintroduction of the battery, in fact, results in a full test of the AED which significantly
affects its longevity. In addition, if the battery is not connected correctly, it may be damaged.
To Next Page
Loading...
