SEMI-AUTOMATIC
20
5.3 CPR Quality module
SMARTY Saver Plus assists the operator in properly performing cardiac massage, during Cardio-Pulmonary
Resuscitation, thanks to the external CPR Quality sensor (SMT-C14034).
This external device (class I) is, in fact, able to measure the depth and the frequency of the compressions performed
and to send this feedback to the SMARTY Saver Plus device via Bluetooth according to the international AHA / ERC
guidelines, for both adult and paediatric patients, as indicated in the table below:
Thanks to the CPR Quality module, the operator can check:
• the correctness of the depth of the compressions they are performing, through the LED bar on the
defibrillator’s keyboard (see figure CPR Feedback)
• the correct frequency/rhythm of compressions through audio signals emitted by the AED.
Compatible external Q-CPR module (SMT-C14034)
• switch the module on by pushing the side on key
• place it on the patient’s chest at the time of CPR
• Perform the compressions, controlling their correctness
through the LED bar on the device’s keyboard and with the
use of the voice instructions emitted by the AED
Progressive LED scale:
• red LED on: insufficient or excessive pressure
• red and orange LED on: not enough pressure
• red, orange and yellow LED on: almost sufficient pressure
• red, orange, yellow and green LED on: correct pressure
Note: For more information on the external Q-CPR sensor (SMT-C14034), please refer to the specific user manual.
To Next Page
Loading...
