SMC Networks HRSH100-A 20 Series - Page 121

HRX-OM-Q026
Chapter 5 Display and Setting of Various Functions
HRSH Series 5.22 Alarm Customizing Function
5-55
Table 5.22-6 Default settings of the alarm customizing function (2/3)
Display
Content
Alarm
Change
Default
Code
Alarm name
Setting function for
"Contact input
signal 1" detection
AL31
Contact input 1 signal
detection
Product operation while the
alarm is being generated
A.STP
Setting function for
"Contact input
signal 2" detection
AL32
Contact input 2 signal
detection
Product operation while the
alarm is being generated
A.STP
Operation setting
when "DC line fuse
cut" alarm is
generated
AL21
DC line fuse cut
Product operation while the
alarm is being generated
A.STP
Temperature alarm
monitoring mode
setting
AL03
Circulating fluid discharge
temp. rise
Monitoring method
0
AL04
Circulating fluid discharge
temp. drop
Monitoring start
timer
AL03
Circulating fluid discharge
temp. rise
Alarm will not be generated
during the set period of time
after starting operation. Alarm
monitoring starts when the set
time has passed.
----
(0)
AL04
Circulating fluid discharge
temp. drop
Range over
detection timer
AL03
Circulating fluid discharge
temp. rise
An alarm will not be
generated for the set period of
time after the circulating fluid
discharge temperature
becomes out of the set range.
5
AL04
Circulating fluid discharge
temp. drop
Compressor stop
alarm
AL10
High compressor intake temp.
Product operation while the
alarm is being generated
P.RUN
AL11
Low compressor intake temp.
AL12
Low super heat temp.
AL13
High compressor discharge
pressure
AL15
Refrigerant circuit pressure
(high pressure side) drop
AL16
Refrigerant circuit pressure
(low pressure side) rise
AL17
Refrigerant circuit pressure
(low pressure side) drop
AL18
Compressor running failure
AL24
Compressor intake temp.
sensor failure
AL26
Compressor discharge
pressure sensor failure
AL27
Compressor intake pressure
sensor failure
AL37
Compressor discharge temp.
sensor failure
AL38
Compressor discharge temp.
rise
AL43

3
Fan breaker trip
AL44

3
Fan inverter error
AL45

2
Compressor breaker trip
AL46
Compressor inverter error
2: Power supply "-20" specification model does not generate this alarm. (Except option S.)
3: Water-cooled type model does not generate this alarm.