Possible to select set alarm 1 mode (on), non-alarm mode (oFF), and
change the set value if alarm 1 mode is selected.
Hold down the set button ( )
for 1sec. or longer to start
parameter change mode.
Select alarm mode (on) or
non-alarm mode (oFF) by Down or
Up button ( ).
To select non-alarm mode (oFF),
hold down the mode button ( ) for
1sec. or longer. To select alarm
mode, hold down set button
( ) to start the mode for set
details.
<Hereafter, only when (on) is set>
Select the limiter mode by Down or
Up button ( ), and hold down
set button ( ). Select by Low
(Lo), up (UP) and hold down the
mode button ( ) for 1sec. or longer
to set the mode.
Select alarm mode by Down or Up
button ( ). Hold down set
button ( ) for 1sec. or longer.
After the value starts flashing,
change the value within the range
of -20 to 120.0%. After changing,
hold down mode button ( ) for
1sec. or longer to set the value.
Hold down the mode button ( ) for
1sec. or longer. Hold down again
for 1sec. or longer after interval
To Next Page
Loading...
Need help?
General
