C
HAPTER
4
| Configuring the Switch
Configuring Security
– 100 –
â–
If the DHCP packet is not a recognizable type, it is dropped.
â–
If a DHCP packet from a client passes the filtering criteria above, it
will only be forwarded to trusted ports in the same VLAN.
â–
If a DHCP packet is from server is received on a trusted port, it will
be forwarded to both trusted and untrusted ports in the same VLAN.
â–
If the DHCP snooping is globally disabled, all dynamic bindings are
removed from the binding table.
â–
Additional considerations when the switch itself is a DHCP client –
The port(s) through which the switch submits a client request to the
DHCP server must be configured as trusted. Note that the switch
will not add a dynamic entry for itself to the binding table when it
receives an ACK message from a DHCP server. Also, when the
switch sends out DHCP client packets for itself, no filtering takes
place. However, when the switch receives any messages from a
DHCP server, any packets received from untrusted ports are
dropped.
PARAMETERS
These parameters are displayed:
◆ Snooping Mode – Enables DHCP snooping globally. When DHCP
snooping is enabled, DHCP request messages will be forwarded to
trusted ports, and reply packets only allowed from trusted ports.
(Default: Disabled)
◆ Port – Port identifier
◆ Mode – Enables or disables a port as a trusted source of DHCP
messages. (Default: Trusted)
WEB INTERFACE
To configure DHCP Snooping:
1. Click Configuration, Security, Network, DHCP, Snooping.
2. Set the status for the global DHCP snooping process, and set any ports
within the local network or firewall to trusted.
3. Click Apply
To Next Page
Loading...
Need help?
General
