4.
Calibration Card × 1
Used for heated bed leveling and Z-axis offset calibration (in manual mode).
5.
Wiping Cloth × 1
And is use for daily cleaning of that print.
6.
Filaments × 2
Materials needed for 3D printing.
7.
Left Door × 1
8.
Right Door × 1
9.
Side Panels × 2
10.
PEI Glass Platform
×
1
A printing platform on which the filament is formed.
11.
Tool Box × 1
a.
USB Flash Drive
×
1
b.
Tweezers × 1
Used to grip excess filament
extruded from the nozzle.
c.
Power Cable × 1
d. Palette Knife × 1
Used to remove the print from
the PEI glass platform.
e. Wire Brush × 1
For cleaning the nozzle.
f.
Diagonal Pliers × 1
Used to cut filaments and remove supports.
g. Filament Holder × 2
To Next Page
Loading...
