Machine maintenance
To ensure that your Snapmaker J1 is in top condition, follow the guidelines in this chapter
to maintain the printer regularly to achieve the desired print results.
Update the firmware
Maintenance scenario
To ensure that your Snapmaker J1 is in top working condition, keep the machine
firmware up to date.
Maintenance frequency
At least once every
three months.
Maintenance method
You can update via Wi-Fi or USB stick.
Wi-Fi
Open the machine > Connect the machine to Wi-Fi > Click Settings > Firmware Update > Download >
Update > Done.
USB flash drive
Download the firmware from the Snapmaker website > Insert the USB disk into the machine >
Open the machine > Click the blank area on the main interface of the touchscreen > Click
USB > Click the firmware file to update.
Clean the nozzle
Maintenance scenario
During the calibration process, some extruded filaments may adhere to the nozzle surface and
make the nozzle surface black. If it is not cleaned in time, it may affect the calibration
results.
After the printing is completed and the nozzle is cooled, the residue of filaments extruded
in the printing process will also solidify and be difficult to remove. If it is not cleaned
in time, it may cause the nozzle to clog or leave a dark mark on subsequent prints.
Maintenance frequency
To Next Page
Loading...
