1.
Start the machine, click Control > Move on the touchscreen, and then tap Home
Button .
2. After the left and right extruders have returned to their original positions,
observe whether the nozzle end has completely entered the wiping pad and is
pressed into the wiping pad for about 1mm-2mm.
3.
If yes, the nozzle wiper is already in the standard position; If not, break
the nozzle wiper by hand until it returns to the standard position.
Check the glass platform plate clamp
Maintenance scenario
The fixture used to fix the glass platform may deviate from the standard position
after long-term use or external force, resulting in the glass platform can not be
fixed correctly, thereby affecting the printing effect. Therefore, its position
needs to be checked regularly.
Maintenance frequency
Once every three months.
Maintenance methods
1.
Ensure that the glass platform and heated bed have cooled to room temperature.
2. Open and close the clamps on both sides of the glass platform, push the glass
platform around by hand, and observe whether it moves.
3. If the platform is not moved, the fixture is already in the standard position;
If the platform can be moved, adjust the clamp position by hand, and then
repeat step 2 until the clamp returns to the standard position.
Maintenance schedule
Before each print
Clean the nozzle
Every month
Remove filament residue from glass platform
Remove the solid glue on the glass platform
To Next Page
Loading...
