Auxiliary mode
1. Click Calibrate > Z-Offset Calibration > Start.
2. Rotate the thumb wheel of the right printhead to align the Z-axis offset of the right
printhead according to the prompts on the touchscreen.
Calibrate the XY axis offset
To ensure that the left and right printheads work at the correct distance in the horizontal
direction, you need to calibrate the XY offset.
Auxiliary mode
1. Click Calibrate > XY Offset Calibration > Start.
2. The left and right extruders will automatically touch the heated bed in turn and
automatically calibrate their offset in the X and Y directions.
Verify the calibration results
You can determine the success of each calibration by printing the built-in verification model.
1. Click Offset Calibration Verification > Start.
2. According to the prompt on the touchscreen, after the verification model is printed,
observe the verification model and judge whether the calibration is successful.
Calibrate vibration compensation
You can calibrate the vibration compensation frequency to improve the print quality of the
model after turning on the suppression compensation.
1. Click Calibrate > Vibration Compensation Calibration > Start.
2. According to the prompt on the touchscreen, after the calibration model is printed,
observe the calibration model and select the best area to complete the vibration
compensation calibration.
03
Load Filament
Before you can start printing with Snapmaker J1, you need to load the printer. filaments need
to enter the extruder inside the extruder and be extruded from the nozzle after being heated
by the heating block.
Snapmaker J1 supports two loading modes – auxiliary loading and manual loading.
To Next Page
Loading...
