By default, the nozzle will be heated to 200°C (392°F). The Load
button can only be clicked when the nozzle has been heated to around
the preset temperature.
Different filaments require different heating temperatures. If the
temperature is not matched, the filament may not be extruded
smoothly. It is recommended to consult the information provided by
the filament manufacturer for more detailed guidance.
Auxiliary loading
In the auxiliary loading mode, the motor will automatically start to extrude
after the filament is inserted into the extruder and engaged. To perform an
auxiliary loading, proceed as follows:
1.
Tap Control > extruder > Slide to Target Temperature > Tap Heat.
2.
Remove the top panel and hang the filaments on the filament holder.
3. Trim the filament ends with diagonal pliers to form a sharp angle of about 45°.
4. Insert the filament into the filament entry until it protrudes from the other
end of the guide tube.
To Next Page
Loading...
