Snapmaker J1 - Waste Disposal

Waste disposal
Waste disposal laws and regulations vary by country and region. When you dispose
of any waste, you should comply with local laws, regulations, rules or
requirements regarding waste disposal.
Packing
The packing box of Snapmaker J1 is made of corrugated cardboard, and the filling
inside the packing box is EPP (expanded polypropylene) and EPE.
(Expanded Polyethylene). These materials are recyclable and environmentally
friendly.
You can save the packing material for future shipment. You can also use your
imagination to create with these materials.
DIY project.
Discarded filaments
Do not discard non-degradable filaments or failed prints in nature. Please throw
them in the designated trash can.
Electronic products
When you no longer need an electronic product or it is nearing the end of its
useful life, you can donate it to a trusted charity, give it to a recycling agency
for recycling, or dispose of it at a designated location in accordance with local
regulations.
88