Snapmaker J1 - Print Menu

When the cut-off detection is turned on, if the machine detects that
there is no filament in the extruder or the filament can not be
extruded smoothly, it will automatically pop up a window to remind.
Room, system log, and compliance statement.
-
To change the machine name, click the machine name and enter the new name.
- To export the system log, scroll down and find the system log column, click Export,
and then click the export method you want.
Change the machine settings
-
To re-enter the wizard process, click Setup > Machine Setup > Wizard.
- To turn on or off the stock break detection for a extruder, click Settings >
Machine Settings, and then click to toggle it on or off.
-
To turn the lighting on or off, click Settings > Machine Settings and then click
the button on the right to toggle it on or off.
- To restore the factory settings, click Settings > Machine Settings > Restore
Factory Settings.
Review the Terms of Use
Click Settings > Terms of Use to view the details.
Print menu
When printing, click Pause or Resume in the print menu interface to pause or
resume printing. Click Stop to stop printing, which cannot be restored.
25