For hanging filaments
h.
USB-B Cable
×
1
Used to connect a printer to a computer.
i. M3
×
6 Screw
×
16
j. M4 × 8 Screw × 4
k.
Hot End Sock × 2
Silicone sock wrapped around the hot end to maintain a stable printing temperature
and prevent bleeding contamination.
l.
Hex Key
×
4
Used to install the enclosure door and side panels, and to maintain the extruder.
m. 5.5mm Wrench × 1
Used to adjust the tension of the belt.
Hardware installation
1.
Place the printer on a horizontal desktop.
To Next Page
Loading...
