Snapmaker J1 - Printer Operation; Touchscreen Initial Settings; General Initial Settings

To re-enter the wizard, click Setup > Machine Setup > Wizard.
touchscreen initial settings
When you first boot the Snapmaker J1, you need to complete a series of initial
settings under the guidance of the touchscreen. Turn on the power switch on the
back of the fuselage, and the touchscreen will automatically run the initial
setup process.
General Initial Settings
When you first turn on the computer, you need to complete the following general
initial settings:
 Select the machine language
 Read Terms of Use & User Experience Program
 Name your J1
 Connect to a Wi-Fi network
Guide
After completing the generic initial setup, the wizard will guide you through the
following steps to prepare for printing:
 heated bed leveling
 Z-axis offset calibration
 XY axis offset calibration

Offset Calibration Verification
 Vibration compensation calibration
21