- Additional safety measures may be required when using materials other than
those provided with the Snapmaker J1. Before use, be sure to review the Safety
Data Sheet (SDS) for each specific material for appropriate safety guidance.
Emergency measures
Burns from hot surfaces
Touching hot surfaces (including hot nozzles, hot ends, heated beds, PEI glass
platforms, and uncured filaments) can burn the skin. If you are burned, take the
following measures in time:
(1)
Keep away from heat.
(2) Immediately wash the burned area with running cold water.
(3) Remove any clothing or jewelry near the burn area.
(4)
Cover the burn with a clean, dry bandage.
(5) Use pain relievers if necessary.
(6) Seek immediate medical attention if necessary.
Inhalation of smoke and particulates
Printing with some filaments may emit fumes or produce particles that may
irritate the respiratory system. Therefore, we recommend that you place the
machine in a well-ventilated place when printing, or use it with air purification
equipment, and wear a protective mask if necessary.
In case of respiratory irritation, let the victim breathe fresh air immediately and
arrange for medical treatment immediately.
Contact with irritant substances
Some soluble filaments may be irritating to humans. Always consult the
manufacturer's Safety Data Sheet (SDS) and take appropriate safety precautions
when handling such filaments.
To Next Page
Loading...
