After printing, please pay close attention to the printing of the
first layer of the model, so as to find problems in time and avoid
wasting filaments. If the first layer does not adhere to the glass
platform, stop printing and see First layer does not adhere.
If the Snapmaker software is disconnected from the printer after
printing has started, the print job is not interrupted.
1. After generating the G-code file in the Snapmaker software, click Send to Workspace.
2. Click the Run button to start printing.
Print via USB drive
1. Insert the USB stick into the computer.
2. After generating the G-code file in the Snapmaker software, click Download to Removable
Disk.
3. Insert the USB stick into the USB port on the printer.
4. On the main screen of the touchscreen, click the blank space to enter the file manager.
5. Locate the G-code file, preview the file, check the print settings, and click Start to
begin printing.
07
Remove the print
When the print is complete, the print is removed from the PEI glass platform.
Wait for cooling
Allow the glass platform and print to cool down to room temperature. As the temperature
drops, the filament itself shrinks, making it easier to remove the print from the glass
platform.
Use the Palette knife
If the print is still attached to the glass platform after cooling, you can use the provided
Palette knife in the tool box to remove the print.
After the glass platform has cooled to room temperature, remove the glass platform and print
from the printer. Insert the edge of the spatula between the print and the glass platform,
and then gently pry to remove the finished product. Try to keep the angle between the
Palette knife and the glass platform less than 30 ° to avoid damaging the PEI coating of
To Next Page
Loading...
