The edge of the Palette knife is sharp. Be careful during operation to
prevent scratches.
Remove the glass platform from the printer before rinsing with
water. Water can cause damage to the printer.
Before removing the glass platform, please make sure that the glass
platform has been cooled to room temperature to prevent hot hands.
Before removing the glass platform, please make sure that the
glass platform has been cooled to room temperature to prevent hot
hands.
Scratch on the edge of the product.
Rinse with cold water
If the glass platform and print have cooled to room temperature and cannot be easily
removed with a spatula, you can wash the glass platform with cold water to help it cool
quickly.
Remove the glass platform and print from the printer and rinse the back of the glass
platform with cold water. When washing, it is necessary to avoid cold water touching the
connection between the glass platform and the printed product, otherwise it may cause
excessive shrinkage and deformation of the printed product.
Soak in warm water
If solid glue is applied to the glass platform when printing, you can use warm water to
dissolve the adhesive.
After the glass platform is cooled to room temperature, take the glass platform and the
printing product out of the printer, and then soak them in warm water to ensure that the
connection between the printing product and the printing platform is immersed in water.
After a few minutes, the glue dissolves and the print can be removed more easily.
If a PVA filament print support is used, simply immerse the glass platform and print in
warm water to dissolve the PVA, making it easier to remove the print.
08
Remove the support
Some model files print without support structure, but most models require support
To Next Page
Loading...
