Be careful when using a carving knife to prevent cuts. It is
recommended to wear protective gloves.
By default, the nozzle will be heated to 200°C (392°F). The Unload
and Load buttons can only be clicked when the nozzle has been heated
to approximately the preset temperature.
Not provided. The burin has a sharp edge and can be used to cut small structures that
require precise control.
Power off and continue to play
To resume a print job if the Snapmaker J1 unexpectedly loses power during printing:
3. Make sure the power cable is plugged in correctly, and then turn on the power
switch.
4.
When the printer restarts, click Restore on the touchscreen.
Replace the filaments
To replace a filament, remove the current filament (i.e., Unload Filament) and then
load the new filament (i.e., Load Filament).
Snapmaker J1 supports two modes of refueling – secondary and manual.
Auxiliary Loading
Auxiliary Unload Filament
1. Tap Control > extruder > Slide to Target Temperature > Tap Heat.
2. When the extruder reaches the target temperature, click Unload. Wait for about
20 seconds, and then click Stop Unloading.
3.
Pull the filament out of the guide tube and remove it from the filament holder.
To Next Page
Loading...
