52
snom 821 User Manual Using the Phone
(Fig. C-2); press again to put the next participant on-screen (Fig. C-3), until you have
reached the last participant (Fig. C-4).
◦ Scroll back through the participants by pressing .
• Bringing the entire conference back on-screen: Scroll to the first participant's screen (Fig. C-2),
then press .
Speaking to one participant in private
1. Put the participant on-screen, as shown in Conference screen navigation, above.
2. Press to put the other participants on hold and talk in private to the participant whose number is
shown on the display.
3. To return to the conference, press and .
Putting one participant on hold
1. Put the participant on-screen, as shown in Conference screen navigation, above.
2. Press .
3. Press to return held participant to conference.
Dropping a participant
1. Put the participant on-screen, as shown in Conference screen navigation, above..
2. Press to terminate the connection to this participant.
Adding a participant
• Adding an incoming call:
1. Press or the blinking line key to accept the call. The conference is put on hold.
2. Press to restart the conference with the additional participant.
• Calling a new participant:
1. Press to put the conference on hold.
2. Dial the number of the new participant.
3. With the new participant on the line, press .
Putting the conference on hold
• If one of the participants is on-screen (Figures C-2, C-3, C-4), you must first return to the screen
with all participants. See Conference screen navigation.
• With all participants on-screen (Fig. C-1), press . Technically, you are ending the
conference; you will see the "Calls on Hold" screen (see Holding multiple calls, Fig. H-4).
• To restart the conference, press .
To Next Page
Loading...
